Product features:
Strong corrosion resistance
High strength, easy manufacturing
Customizable single/double row
High precision
Core technology:
Special material welding process
Precision welding process
Lubrication tube draw process for stainless steel pipes
Wire drawing process for stainless steel pipes
Electrolytic polishing process
Flow drill process
Vacuum brazing process
Product advantages:
Material traceability
Complete process data
Customized service
Spot raw material
Project resource integration
Manifold specification | Content |
Working temperature | 5℃-70℃ |
Storage temperature | -40℃-80℃ |
Working media | 25% propanedione liquor, pure water |
Loading capacity | 10bar |
Main tube design flow | 40LPM |
Branch tube design flow | No more than 1.2LPM |
Main tube flow capacity | 0-40LPM |
Material | 304 stainless steel |
Manifold port | 50.5mm chuck |
Model picture
Structure
introduction
- Manifold is made of 304 stainless steel square tube in
40x40x3mm；
- A set of Manifold components consists of two manifolds plus a
base plate, one supply and one return, fixed through the bottom
plate；
- A single Manifold has a total of 28 branches, the interface
position is evenly arranged, the center of the branch is aligned
with the center of the cabinet column U mark, and the branch
spacing is 2U (88.9mm)；
- The bottom of the manifold is mounted with a barbed structure,
which is connected to one end of the flexible hose assembly and
the other end is connected to the secondary main piping loop by a
set of self-sealing interlocking ball valves；
- Manifold is equipped with an automatic gas release valve on the
top, which is selected from imported brands. The bonnet, valve
body, float, lever, valve seat, etc. are all made of 304 stainless
steel; The manifold is installed vertically in the cabinet, the
automatic gas release valve is in a vertical state, which is
convenient for automatic gas release.
Technical
parameters
1. The maximum working pressure inside the manifold is 10bar,
and a proof pressure test will be done before shipment；
2. Manifold is welded with 304 stainless steel; The welding process
should comply with relevant national standards；
3. Manifold needs to rinse the impurities in the tube before
shipment, drain the internal liquid after rinsing, and seal it, and
all interfaces connected with the outside are sealed with plugs or
blinds to prevent impurities from entering the packaging,
transportation, loading and unloading process；
4. With the threaded hole as the center, within the diameter of
18mm, the surface roughness of the manifold meets the requirements of Ra1.6；
5. After the corresponding parts (plugs, plugs or hose assemblies)
are installed in the Manifold branch, the perpendicularity of the
parts to the surface of the Manifold is ≤ 0.1mm.
